Franklin-fueling-systems T5 Series Fuel Management System Programming Guide Manual do Utilizador descarregar pdf (Página 27)

4-20 mA and 4-20 mA EXP Input Modules

The Analog Input Module has 8 identical channels for loop powered IS sensors with a 4-20 mA interface.

The 4-20 mA EXP module is programmed in the same manner. The 420 EXP module is located on the hazardous side of

the console, must have the wires enclosed in explosion-proof conduit, and has a red front. If a DTU is being used there

will be an option for a “virtual module” labeled Remote Module. The Remote Module gathers information from the vapor

pressure sensor when a DTU is used. (see DTU Programming for further details on page 31 in this manual.)

Group Name

Parameter

Name

Parameter

Default

Description Parameter Input

4-20mA Input Modules

Module # Channels (0) Number of channels in use per module. 0-8

Channel #

Name (4-20mA Input 1) Given name of the channel. abc#

Service Type (Analog) Determines the input signal.

Analog

Secondary Containment Monitoring

Line Leak Detection

Vapor Recovery Monitoring

FMS Level Probe

Low Range -8.00 Low range of mA input - #

High Range 8.00 High range of mA input + #

#3 Remote

Module 2 (DTU)

Channels (0) Number of channels in use 0-5

Name 4-20 mA input 6 Given name of the channel abc#

Service Type (Vapor Recovery) Determines the output signal Vapor Recovery Monitoring

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 65 66

Sem comentários

Franklin-fueling-systems T5 Series Fuel Management System Programming Guide Manual do Utilizador Página 27