Franklin-fueling-systems T5 Series Fuel Management System Programming Guide Manual do Utilizador descarregar pdf (Página 13)

Obtain an IP Address Automatically

Computers commonly use this setting to obtain an IP

address automatically.

1. If Obtain an IP address automatically is selected, it

may be best to click the Alternate Conguration tab.

2. Select User Congured.

3. Enter an IP address. For simplicity, make the last

segment of the IP one number different than the IP

address of the console. Upon initial setup ONLY, the

numbers used in the gure may be used to congure

the TCP / IP settings of your PC.

4. Leave all other information blank and click OK.

5. Close the Local Area network for changes to take place.

Note: The consoles default IP address is

192.168.168.168. If the PC is normally congured

to acquire an IP address automatically, Alternate

Conguration may be used, as mentioned above, to

allow a connection to be enabled without the necessity

of reconguring the computer each time it will be used

to connect to this console.

Use the Following IP Address

If Use the following IP address is selected and the entry

boxes contain any information, record this information for

use when console programming is complete.

2. Enter an IP address. For simplicity, make the last

segment of the IP one number different than the IP

address of the console. Upon initial setup ONLY, the

numbers used in the gure may be used to congure

the TCP / IP settings of your PC.

3. Leave the DNS information blank.

Note: The consoles default IP address is

192.168.168.168. If the PC is normally congured

to Use the following IP address, make sure that

all displayed information is recorded and kept prior

to making any changes. It may be necessary to use

this information to recongure the console once

programming is complete.

Check Status of Connection

1. Check the status of your connection by going to the

Network Connections window.

2. If the connection status is disabled, enable it by right-

clicking on the Local Area Connection and selecting

Enable.

3. Verify link light is lit under Ethernet on Controller

module is lit and RX light is ashing.If technical

difculties arise, please contact Franklin Fueling

Systems Technical Support before proceeding.

More information on the Web Browser Interface is located

on page 33 of this manual.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 65 66

Comentários a estes Manuais

Sem comentários

Franklin-fueling-systems T5 Series Fuel Management System Programming Guide Manual do Utilizador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Equipamento Franklin-fueling-systems T5 Series Fuel Management System Programming Guide