Franklin-fueling-systems T5 Series Fuel Management System Programming Guide Manual do Utilizador descarregar pdf (Página 14)

Connecting a PC to the T5 series RS-232 Port

COMM 1 is used to connect a PC or laptop with the console via the Web Browser Interface for programming or remote

monitoring. COMM 2 is used only for VRM to retrieve ullage data from an external ATG.

If serial connection to Point-Of-Sale (POS) is desired for report retrieval, then we suggest using COMM 1 in Veeder-Root

(VR) mode.

Note: The PC or laptop will recognize this serial connection as a network connection and will not allow the use of a Local

Area Connection simultaneously. While it is not necessary to disconnect the Local Area Connection to connect

using the Serial port, it will be necessary to disconnect the Serial Connection through the computers operating

system in order to use the Local Area Connection again.

Connecting a PC to the T5 series COMM 1 Port

1. Using a female to male DB-9 straight serial cable, connect the female end of the serial cable to the serial

communication (COM) port of the computer.

2. Connect the male end of the serial cable to COMM 1 on the bottom of the console.

Console Conguration

→

Mode: Network Connection (PPP)

Baud Rate: 57600

Data Bits: 8

Parity: None

Stop Bits: 1

Conguring COMM 1 Settings for

Communication

1. Select Start > All Programs > Accessories >

Communications > New Connection Wizard.

2. Select Set up an Advanced Connection.

3. Select Connect Directly to Another Computer.

4. Select Guest.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 65 66

Sem comentários

Franklin-fueling-systems T5 Series Fuel Management System Programming Guide Manual do Utilizador Página 14